Merging in Model Builder

820
1
11-21-2011 11:00 AM
chadhickman
Occasional Contributor III
I haven't used Model Builder really at all, I was wondering if someone could help me out. I have polygons in five different regions of the state and want to merge them all into one statewide coverage. I am trying to do this through model builder by using the merge branch, the model appears to run however I see no output and I am unable to browse to select an output. Any help would be much appreciated.
0 Kudos
1 Reply
JimW1
by
Occasional Contributor II
I haven't used Model Builder really at all, I was wondering if someone could help me out. I have polygons in five different regions of the state and want to merge them all into one statewide coverage. I am trying to do this through model builder by using the merge branch, the model appears to run however I see no output and I am unable to browse to select an output. Any help would be much appreciated.


Try 'Merge' and not 'Merge Branch'
0 Kudos