Iterate Featue Modelbuilder

333
1
Jump to solution
10-02-2013 09:59 AM
RachelAlbritton
Occasional Contributor III
I am trying to use the iterate feature tool in model builder to go through a point files records one by one and complete a series of geoprocessing steps for that point. The model will only run on the first four points and says its complete, however there are seven points in the file. Why would this be happening? I've attached a png file of the model in case it would be helpful.
0 Kudos
1 Solution

Accepted Solutions
RachelAlbritton
Occasional Contributor III
I figured it out. I had to switch the position of the observation points make feature layer and the iterator.

View solution in original post

0 Kudos
1 Reply
RachelAlbritton
Occasional Contributor III
I figured it out. I had to switch the position of the observation points make feature layer and the iterator.
0 Kudos