% Complete bar jumping around

404
2
11-21-2011 02:12 PM
by Anonymous User
Not applicable
Original User: SStrand

I have never seen this before but when I am using model builder with beta 2 to clip a raster and then convert it to a polygon, the % complete bar that scrolls across for each process will count up 3-5% and then go down 2% and then count up 3-5% and then go down 2%. This only occurs when the process is very quick, so the bar quickly jumps right, left, right, left. Has anyone else had this happen ever?
0 Kudos
2 Replies
by Anonymous User
Not applicable
Original User: LMuehlius

I have been building some address locators and have noticed this too. The status was up to 80% complete and then went back to numbers less than 10. Once it did that, the numbers are progressing in order (i.e 10s, then 20's ). 30 seconds after the address locator started, the Background Processing area disappeared for awhile too. Don't know if this is normal. It did come back.

Loren
0 Kudos
LorenMuehlius
New Contributor III
I better clarify my previous comment. I am using beta 2 and the window itself didn't jump around. I was creating the address locator for a 2 million plus record set, so it did take some time.

Loren
0 Kudos