When using the feature class to geodatabase tool, it only copies the first feature?

[JustinJohnston]

Hi,

When using the feature class to geodatabase tool, it only copies the first feature.  I am not sure why this happens.  Maybe it is because I have the GDB saved on a Sharepoint site?  It seems to work ok if I create a feature class and make edits to it.  But I used the Grid Index tool to create a grid index for a mapbook and the index only has the first sheet after using the Feature Class to Geodatabase tool.  If I use Feature Class to Shapefile, and point it to a sharepoint site file location, it does the same thing.  However, if I use Feature Class to Shapefile, and then point it to a desktop location, it seems to work ok.  I still cannot however get that shapefile to then get into my GDB.  Any ideas?  Do I have to not be saving GDBs on a Sharepoint site?  It is important to be doing that so I have backups of Project data.  It is frustrating to me that ESRI has not made ArcGIS Pro more Sharepoint friendly.  

Cheers,

Justin

[DanPatterson]

Could you rule out the obvious.  Make sure that there are no selections in the featureclass you are trying to export (use the Clear button)

[JustinJohnston]

I did that last time and it did not work.  Having restarted my computer however, confirming that it is cleared, it seems to have worked this time.  All features transferred.  I am reluctant to call that "Clearing" or "restarting" the solution though as I have experienced this issue many times in the past. It isn't always one feature that copies either.  Sometimes a few go at random.  

Cheers,

Justin

[DanPatterson]

Rebooting doesn't "clear" selections.  By that I mean a feature may have been inadvertently selected in the map or a record was selected in its table.  It is the most common source of "only X of Y features were exported". 

Glad it worked out in any event... A reboot would have been the next suggestion.

[JoeBorgione]

When in doubt...