ArcPro 2.9.0 crashed using Select by Attribute

226
6
12-16-2021 01:14 PM
Labels (3)
Hamg
by
New Contributor II

Hi all, 

Upgraded ArcPro 2.9.0 and its crashing when using Select by attribute process. I have tested it with different datasets but getting the same results. 

Any recommendations would be helpful. 

 

Thanks 

Hussain

0 Kudos
6 Replies
DanPatterson
MVP Esteemed Contributor

If it just crashes without any error, then you probably have a bad install.

Try  Add/Remove Programs (windows), Select "Remove" then "Repair".  A reinstall will be attempted.

Should that not work, then you will have to reinstall completely from the *.msi if you downloaded and saved the *exe and installed from it


... sort of retired...
0 Kudos
Hamg
by
New Contributor II

Thanks @DanPatterson , I will give it a try. 

0 Kudos
DanPatterson
MVP Esteemed Contributor

Did you get this resolved?


... sort of retired...
0 Kudos
Hamg
by
New Contributor II

No, not yet. I am out of the office for Christmas, and I will update you once I am back in the office. 

Thanks 

H

0 Kudos
Hamg
by
New Contributor II

Hi @DanPatterson ,

Just wanted to update on you, I have installed the new copy of the ArcPro 2.9 and its still crashing on me. so I am going back to 2.8 for now. 

 

Thanks 

Hussain

0 Kudos
DanPatterson
MVP Esteemed Contributor

Tech Support would be best since there must be something fundamentally wrong since I don't see any error reports that are public


... sort of retired...
0 Kudos