ArcPro 2.9.0 crashed using Select by Attribute

[Hamg]

Hi all, 

Upgraded ArcPro 2.9.0 and its crashing when using Select by attribute process. I have tested it with different datasets but getting the same results. 

Any recommendations would be helpful. 

Thanks 

Hussain

[DanPatterson]

If it just crashes without any error, then you probably have a bad install.

Try  Add/Remove Programs (windows), Select "Remove" then "Repair".  A reinstall will be attempted.

Should that not work, then you will have to reinstall completely from the *.msi if you downloaded and saved the *exe and installed from it

[Hamg]

Thanks @DanPatterson , I will give it a try. 

[DanPatterson]

Did you get this resolved?

[Hamg]

No, not yet. I am out of the office for Christmas, and I will update you once I am back in the office. 

Thanks 

H

[Hamg]

Hi @DanPatterson ,

Just wanted to update on you, I have installed the new copy of the ArcPro 2.9 and its still crashing on me. so I am going back to 2.8 for now. 

Thanks 

Hussain

[DanPatterson]

Tech Support would be best since there must be something fundamentally wrong since I don't see any error reports that are public