Thank you Jeffrey.
The table in the list is filtered perfectly on selecting a polygon, however, it starts up with the full list, where I want it to show: "No Data"
Maybe I don't understand this correctly, but my workflow and data is:
A polygon layer with building lots
A table with address points (Point layer, but are not using the points to select. This table is filtered out by the selection of the Lot polygon in a list, and by clicking on an address in that list, it's filtering out 2 lists with owners and administrators)
A table with information about Lot owners
A table with information about Lot administrators
A table with information about unit/department owners
A table with information about unit/department administrators
The filtering of all these tables works, but when I open op the Experience builder, I want to be presented with no data in the lists that contain tables, until a lot is chosen.
Thanks