I have been playing around with geocoding the past little while, and I am pretty sure I have set everything up right, but whenever I try to search for an address and see where it would be on my map, it always tells me that nothing is found.
When I browse through with the Address Inspector tool, it show what address should be at that exact point. But, I want to use the search function to input any address, so that it can show me where it should be.
The labelling is all pretty basic (it's a rural area, so all the roads are just mile roads ("Road 23W"), and the addresses are 4-6 digit numbers based on how far they are from the next mile road), so I didn't think it would cause this much of a headache.
Any help would be greatly appreciated!
Thanks!