How do you folks handle multi-part subdivisions in the parcel fabric? I have several that describe the parts on either side of the road and not the road itself. When I enter both parts then merge them to get one record for the subdivision I lose the origin connection lines. Does missing the origin lines affect how things are adjusted when an LSA is done on the fabric? Should I leave them as separate polygons with the same name?
Thanks,
Jeff Ward
Summit County GIS
Solved! Go to Solution.
The best approach to entering a mutli-part parcel with an origin connection is as follows:
If you have already created the multipart and merged the parcel and want to re-add the Origin Connection:
To answer your other questions:
The best approach to entering a mutli-part parcel with an origin connection is as follows:
If you have already created the multipart and merged the parcel and want to re-add the Origin Connection:
To answer your other questions:
Thanks Jason Camerano, I will follow the process you outlined.
In cases where there isn't a connection line described (separate, distant portions that use a POB and tie point) would I just enter more origin to POB lines for the second or third parts after entering the traverse for the first part? Or should they be connection lines? I ask this because I'm not sure what process/fields/lines the LSA utilizes to adjust the fabric. Is there a diagram or something that shows the LSA adjustment process, what fields it uses to make adjustments?
Thanks,
Jeff
For a single parcel there should only be one area where Origin Connection lines exist. You can have multiple Origin Connection lines that follow a linear path to the POB, but elsewhere in the parcel there should be no other Origin Connection Lines. All other tie lines should be Connection lines.
Here are a couple links that might be helpful to better answer your questions: ArcGIS Help (10.2, 10.2.1, and 10.2.2) , ArcGIS Help (10.2, 10.2.1, and 10.2.2)
I followed your process and I was able to merge a multi-part subdivision into a single subdivision. Two of the satellite parts we were able to create with connection lines, but two others didn't have anywhere that we were able to create connection lines to start the part. So we created them as individual subdivisions and merged them into the original, then recreated the origin to POB lines. I will mention that to create the origin lines, we had to unjoin the merged subdivision, create the lines reverse the from-to points and reverse the bearings and then join it again.