XY to Line generated incorrect output

317
2
Jump to solution
05-02-2021 01:02 PM
HarryHattusa
New Contributor

Hi!  The title and the screenshot say it all, really-- I tried using the XY to Line tool to generate lines between two sets of coordinates.  Some of them went fine, and for some of them, I got...this mess?  Most of the lines should end within the confines of Greece, not go arcing off into the wild blue yonder.  Any troubleshooting tips?

0 Kudos
1 Solution

Accepted Solutions
HarryHattusa
New Contributor

I figured out the problem, and it was in the input data.  Could a mod delete this thread so nobody wastes their time on it?

View solution in original post

0 Kudos
2 Replies
HarryHattusa
New Contributor

I figured out the problem, and it was in the input data.  Could a mod delete this thread so nobody wastes their time on it?

0 Kudos
DavidPike
MVP Frequent Contributor

What coordinate system are you using, and what coordinate system are the points in?

It's likely incorrect coordinates supplied or the wrong coordinate system/projection being used in the tool environment settings or a mismatch of both. 

0 Kudos