Trace Geometric Network: Edge Barriers

1070
0
07-25-2016 04:19 PM
MarkCederholm
Regular Contributor II


I've noticed that the Trace Geometric Network geoprocessing tool does not honor complex edges:  if an barrier is placed on an edge feature between junctions, the entire feature is disabled, rather than treating just the sub-edge as disabled.  This is not consistent with tracing behavior using the Utility Network Analyst toolbar in ArcMap, or using a TraceSolver in ArcObjects.  Has anyone else noticed this, and/or found a workaround?

0 Kudos
0 Replies