Select to view content in your preferred language

Trace Geometric Network (FindPath) Edge vs. Junction Pts

456
0
04-06-2017 11:09 AM
by Anonymous User
Not applicable

I am running a FindPath on two points. The two points have been snapped to the geometric network. One landed on a junction, one landed on an edge, apparently

I am getting the following error when I run Trace Geometric Network with the "FindPath" option

both junction and edge origins are specified for FindPath

I cannot prevent points from snapping to junctions, so how can I rid myself of this annoying error? I will do this a LOT, so it would be nice if I didn't have to futz around with the points to make sure none happen to land on junctions.

Is there a way to say "ignore junctions" or "treat junctions as edges"

Thank you very much,

Randy McGregor

0 Kudos
0 Replies