Substation Tracing

[KokilaM]

Hi Team,

I'm currently setting up the trace configuration inside an electric substation as follows:

• Up to the Step-Down Transformer → Transmission Tier subnetwork
• Step-Down Transformer to Circuit Breaker → Distribution Tier Subnetwork A
• From the Circuit Breaker onward → Distribution Tier Subnetwork B

After configuring the subnetwork controllers, I ran Update Subnetwork. My expectation was that Subnetwork A would trace only up to the Circuit Breaker. However, it is tracing past the circuit breaker instead of stopping there.

I've also confirmed that the controllers I defined are all set for the Distribution Tier only.

Could you help me understand why the trace isn't terminating at the circuit breaker as expected?

@RobertKrisher @MikeMillerGIS 

Thanks

[MikeMillerGIS]

What settings did you us in the Trace?  Did you set a target tier?  

[gis_KIWI4]

@KokilaM - we got past this by setting a traversibility filter in the subnetwork definition to stop at a subnetwork controller.