Select to view content in your preferred language

3D sceneview extrusion for shapefile

316
0
03-14-2022 03:16 AM
TayLee
by
Emerging Contributor

I have created a FeatureLayer for a shapefile (contains buildings shapes in our country) and setup the properties to enable extrusion.

However, almost all buildings on the shapefile were extruded the moment I go into 3D - even buildings that were too far away and irrelevant were extruded.

This results in a very unusable map : can't see anything, and the whole experience is sluggish.

How can I optimize this behaviour?

Appreciate any advice, thanks in advance! 

0 Kudos
0 Replies