Select to view content in your preferred language

Updating parcel lines after modifying parcel polygon

210
2
Jump to solution
08-07-2025 11:54 AM
dgiersz_cuyahoga
Frequent Contributor

We used to map condominium parcels with points. When we moved to Parcel Fabric, we converted them to polygons using their minimum boundary area. This worked fine, but the resulting polygons are too small (2 feet by 2 feet). I created larger polygons to replace them with, but are unsure on how to then update the parcel lines which remain at 2' length. 

Is there a way to get the 2' lines' geometry updated or do they need deleted and recreated?

 

#CLE #sloth
0 Kudos
1 Solution

Accepted Solutions
AmirBar-Maor
Esri Regular Contributor

@dgiersz_cuyahoga 

I think the answer depends on whether or not you care about the lines. 

If you do not care about them, just delete the lines and the points that defined the old 2'x2' footprints, the 'correct' lines and points will be created once you press build.

View solution in original post

0 Kudos
2 Replies
AmirBar-Maor
Esri Regular Contributor

@dgiersz_cuyahoga 

I think the answer depends on whether or not you care about the lines. 

If you do not care about them, just delete the lines and the points that defined the old 2'x2' footprints, the 'correct' lines and points will be created once you press build.

0 Kudos
dgiersz_cuyahoga
Frequent Contributor

Thanks for the reply! We don't care about the lines, they were autogenerated after the 2'x2' polys were created.  

#CLE #sloth
0 Kudos