Hi—Have downloaded trial Drone2Map, and while trying out a few of the samples, once I click Start to process a sample, following the steps provided, the bottom status bar appears to be processing for a few seconds, and then it returns to "Ready Completed.", showing 100% in the status bar, but no 2D Products and no 3D Products are added to the project as is stated in the sample instructions. What am I missing, or is it still processing in the background?
Downloaded the program again. Ran a repair installation. Started processing, and it looked like it was working.... It did process for a bit longer, but after just a few moments, the process said it is 100% completed, and no products are showing up as per the sample instructions. The Processing Report is also not available. If Start is selected again, the processing is almost instantly completed, 100%, even if one selects full rather than rapid processing.
Removed and reinstalled Drone2map software. Attempt at processing on Rapid sample project took 1.5 minutes and says it Completed 100%. However, still no 2D products showing up. And Processing Report button is not available. Still looking for help on this. Thank you.