Collector Location Profile Issue

[JasonSladinski1]

I've been using Collector for several months and have a GNSS receiver that uses a RTK correction service that's in NAD 1983 2011 and my map/features are in NAD 1983 2011 and have a profile created for that.  Every time I open the map with that profile selected, I get kicked out and get an error that says the wrong location profile is being used.  I then switch to the Default profile, open the map and get the same error, but am able to close the error and the map stays.  I then go back to select my NAD 1983 profile and then everything is fine.  Is anyone else having a similar issue?  My map does use the Ersi Imagery Basemap, so I'm not sure if maybe that may cause an issue or if it's something else.

Thanks!

[MiaogengZhang · Accepted solution]

Jason,

The webmap coordinate system is based on basemap. If you are using Esri imagery as basemap, you should create location profile with WGS1984 Web Mercator (3857) as map coordinate system. 

-Morgan

[PanGIS]

Old post and no one marked you answer,  I'll do.....

Anyway, you made my day.

[OrrinBabcock]

I have a similar question. I've created my location profile and am able to locate all my data collected on another device. I am unable to collect data with Collector correctly. I create a point and watch it get created 3 feet away from my location indicator and have to physically move 3 feet to "locate" the point I just created. I have no idea why my location profile allows me to accurately locate my data but doesn't allow me to collect accurately.

[MichaelGeorge1]

Was there ever a solution to this reply?