Terrain issue

655
2
12-08-2016 02:07 PM
KristinaJarmalaviciene2
New Contributor

Hi,

Could someone explain me why I get this wall when I add terrain? This was created from LIDAR xyz points with IDW. 

Then I used raster clip to make smaller tif.

0 Kudos
2 Replies
LR
by
Occasional Contributor III

Check the raster edge's values to make sure they aren't 0. In CE, select the layer, somewhere on the right in the inspector is "value filtering", try turning it off.

I've seen this usually happen with non-rectangular rasters.

0 Kudos
KristinaJarmalaviciene2
New Contributor

L R,

Thanks! This helped me

0 Kudos