ArcScene resolution confusion

[ChristopherJursa]

Hello,

I am using ArcScene with ArcGIS 10.

I have a raster image I have krigged.  Whenever I load the layer into ArcScene, it loads fine.  However, when I attempt to change the symbology, the resolution of the layer becomes low as if there is an error.

I have two other rasters in different projections.  Could this be the cause?

Has anyone encountered anything like this?

[TimothyHales]

Try adjusting the "Quality Enhancement" setting to see if the resolution improves.

Optimizing raster and surface layers

[ChristopherJursa]

That didn't seem to help.

[TimothyHales]

What type of symbology changes are you doing?  Does the raster display better before changing the symbology are is it the same?

[ChristopherJursa]

Thanks for the help so far.  I don't think the quality enhancement is the issue either.

I opened a second ArcScene window and loaded the layer and had no difficulty with it.  I then copied it and pasted it into the first ArcScene project.  This seemed to solve the problem.  It is a strange workaround though. 

I think there is an issue with the projection of the data frame.

[JeffreySwain]

I recommend keeping all of the layers in ArcScene  in the same projection. Since ArcScene is so memory intensive, there can be issues when a transformation needs to take place.  Keeping the projection will prevent some of the potential display issues you are describing.