Routing failure using Campus Viewer tools?

10-30-2017 09:21 AM
New Contributor

I have succesfully created an indoor network using the Campus Viewer Indoor Network tools.  I can perform a successful only when my 'Stops' reside on the same floor.  I cannot produce a successful route when my 'Stops' are on different floors.
Some things to note..
1. I am importing points from another layer to the 'Stops' layer.  These imported points have z values and display properly in ArcGIS PRO scene.

2. The points are situated near a Transition layer for stairs.

3. My 'Route' parameters are set to use stairways as a high preference.


0 Kudos
0 Replies