Latest Contributions by ViTran2

‎08-05-2019

Hi all, I recently processed a project where I flew over a detention pond (with water). This time, I flew the drone right after a storm. The first half of the flight, there was no sun, all overcast, but at mid-mission, the clouds started clearing up and the sun was peaking out intermittently. This caused the images to have different colors (not sure if I described it correctly.) Please view the image below. Overcast: Sun was exposed: To make the matter worse, some photos show the reflection of the sun in the water, like this one here: Do you think this is the reason for the problem in the question? I'm able to view the point cloud just fine. I can choose to view the point cloud in RGB. And to be clear, I ran the project with the new version 2.0 of D2M. If the problem is indeed because of the image quality, is there anything I could do to prevent this situation in the future, e.g. omit these bad photos, fly another round over the site, pick a better day? Any input is highly appreciated.

‎07-24-2019

Thank you for your prompt answer. I'll discuss this with our team to update our network datasets.

‎07-17-2019

Hi, I have a model (built in ModelBuilder) to run a chain of Make Service Area Layer - Add Locations - Solve tools. Recently, I tried to run this model in ArcGIS Pro and found out that the Make Service Area Layer tool was deprecated. Hence, I switched to the Make Service Area Analysis Layer tool. However, when inputting the Network Dataset from our SDE, the Travel Mode attribute doesn't show a drop-down list of options like the (assumed) equivalent "Impedance Attribute" from the predecessor tool. So I tried to type in the name of for travel mode as CostLength (We have 2 travel attributes: Cost (driving time) and CostLength (distance)), and the cutoff value to be 1320 (i.e. 1320 ft). The tool ran but apparently based on the result, I can tell it didn't interpret the cutoff value to be 1320 FEET. As this moment of typing, I cannot find the Make Service Area Layer tool in Pro anymore, but can still copy that tool from my old model, and the new model runs fine. I'm wondering if anyone has any input for this issue? TIA.

Online Status	Offline
Date Last Visited	‎11-11-2020 02:25 AM

My Ideas

Latest Contributions by ViTran2

Point cloud was created but none of the 2D products was

Re: How to set Make Service Area Analysis Layer travel mode

How to set Make Service Area Analysis Layer travel mode