Hi,
I am tying to reclassify a certain range of values (e.g. > 2) and in the same time keeping old values as they were in the input raster.
When using Reclassify all values are reclassified even if I have left them out. Any suggestions?
I had this problem when I used ArcMap 9.1 before, then it got fixed in 9.3 but seem to have repapered again in 10.
I am tying to reclassify a certain range of values (e.g. > 2) and in the same time keeping old values as they were in the input raster.
When using Reclassify all values are reclassified even if I have left them out. Any suggestions?
I had this problem when I used ArcMap 9.1 before, then it got fixed in 9.3 but seem to have repapered again in 10.
http://help.arcgis.com/en/arcgisdesktop/10.0/help/index.html#//009z00000005000000.htm