Model builder, process hanging on Near Tool (Analysis Tools, Proximity)

11-01-2012 06:52 AM
New Contributor II

I have produced rather a large model in Arc10, service pack 4. I have a few Near Tool processes within the model. When I run the model as a whole it will hang on a couple of these Near Processes and just won't carry on, or takes ages and write the information as -1 only!

If I have the model open in edit mode and cancel the process when it starts to hang, I can carry on where it stopped and the near analysis works fine, so there is nothing wrong with any of the inputs etc.

I just need to be able to run the whole Model in one go without this hanging problem, anyone have any ideas?

Thanks and Regards

0 Kudos
1 Reply
Esri Regular Contributor
Please can you share the model and the data/sample of the data?

Are you using 10? sp?
0 Kudos