I'm trying to georeference a tif file (no spatial data but showing township-range-sections) against a NAD 83 t-r-s map I have for the same area. Everything is fine until I turn on auto adjust. If I turn it on before selecting control points, my tif image disappears at the 2nd control point. If I first establish some control points (say 2 - 4) and then turn on auto adjust, the tif image then disappears (even when my RMS error is shown as very low).
Any ideas/suggestions? I don't know if this is a problem with what I'm doing or a corrupted file issue.
Thanks,
Dan