Address Table Won't Geocode

687
2
Jump to solution
01-06-2014 06:05 AM
Highlighted
New Contributor III
I am trying to geocode a list of address (which I have done before with out issue) but I either get an error message that there is a problem with the table or ArcMap 10.1 just up and crashes on me.

The data is in an excel file and is a list of vehicle addresses (street address, city, state, zip).

Stumped. :confused:
Tags (2)
Reply
0 Kudos
1 Solution

Accepted Solutions
Highlighted
New Contributor III
I'm not sure if it was the right correction but I removed the locator and added it back following the steps shown here: http://support.esri.com/fr/knowledgebase/techarticles/detail/36444

Geocode works again!

View solution in original post

Reply
0 Kudos
2 Replies
Highlighted
New Contributor III
I'm not sure if it was the right correction but I removed the locator and added it back following the steps shown here: http://support.esri.com/fr/knowledgebase/techarticles/detail/36444

Geocode works again!

View solution in original post

Reply
0 Kudos
Highlighted
Esri Regular Contributor
The service that is described in this Knowledge Base Article was retired at the end of 2013 but will be completely shut down at the end of January and you should start using the new geocoding service (http://geocode.arcgis.com).

Here is a link on how to set it up for batch geocoding in 10.1:  http://resources.arcgis.com/en/help/main/10.1/index.html#//00250000004v000000

Brad
Reply
0 Kudos