Hello,
I'm trying to run the LAS Statistics to raster tool on a .lasd file, where I apply different filters. The idea is to get a sense of point density based on those filters. However, no matter what filter I apply, I always get the same result...
Now, I was under the impression that those filter options where not just for display. Am I doing something wrong or is it just not possible to use the filters for tool actions?
Thanks for clearing this up!
Solved! Go to Solution.
It turns out that the method applied was the problem. I was choosing "Pulse count" since I wanted the last returns. But since I was already applying similar filters on my file, the output was pretty much always the same. I had to select "Point count" to get what I was looking.
It turns out that the method applied was the problem. I was choosing "Pulse count" since I wanted the last returns. But since I was already applying similar filters on my file, the output was pretty much always the same. I had to select "Point count" to get what I was looking.