Creating composite locator in ArcPro

265
0
05-21-2021 12:30 PM
Labels (1)
BobBoutiette
New Contributor II

I am creating a composite locator from an address point layer and a street layer. The points and streets are in state plane.  When using state plane, the point, street and composite locators all work in ArcPro. After publishing the composite, locator results are a state away.  I change all locators to WGS84 and republished a composite.  The address is placed in the right place however the viewport zooms to Africa at the start.  I have to zoom out to globe level and then zoom in the Tennessee to find where the address was placed. 

The composite locator works when added to the ArcPro project from the local network but when adding the published composite from the Arc Server everything goes haywire.  I must have something out of whack. 

Tags (3)
0 Kudos
0 Replies