Select to view content in your preferred language

Configuring popups

414
2
01-30-2024 03:14 PM
Labels (3)
GIS412
by
Occasional Contributor

Hello,

I have a question about configuring popups.

I'm been asked to configure a popup to show all the fields in it's attribute table. I have completed this task, but will I need to republish the layer for the newly configured popups to show up? Or I can make the popup changes within the project, save it, and when a user clicks on a symbology with the newly configured popup, all the additional fields will be shown?

Thanks!

0 Kudos
2 Replies
Eugene_Adkins
Frequent Contributor

If your service was originally published with all the fields marked as viewable but afterwards you restricted the viewable fields on the published service side, you can make your previously hidden fields viewable in the configure pop-ups control … but if your service was originally published with viewable field restrictions (i.e. not all the fields were marked viewable), then you will need to republish your service.

0 Kudos
GIS412
by
Occasional Contributor

Thank you!

0 Kudos