I'm having a persistent problem in AGOL. I make a mundane layer, like a drive-time layer or something, and when I go to use "enrich layer", I can click on it, but it doesn't work. It doesn't bring up the parameters, its as if I didn't click on it.
If I exit the map, make a new map, stick in the layer I want to enrich in this new map, I can enrich no problem. Then I exit the new dummy map, re-open my old map, and add the enriched layer, and I can use it fine. This has been going on for about 2 months, and persists across new maps, old maps, new layers, old layers, whatever.
Is this a bug? Anybody else have this?
I just did a test. I normally use Chrome (recent version), but fired up IE 11 to try, same behavior.
I tested from home, on a Mac, with all 3 browsers. Same result, can't enrich in one map, stick it in a blank map, no problem. Very irritating!!! I guess I'll have to do a support incident.
I just experienced the same issue. I can't get anything to happen when I click on Enrich Layer. All the other Analysis tasks seem to work fine.
I did a support incident. Basically, the resolution of it was "sometimes maps get corrupted, so start over with a fresh map, re-add your layers, and it will be OK". And that was correct, but not at all amusing.
Good luck!
Thanks Jay. Not amusing indeed.