Geocoding and getting uniquefeatures

476
3
Jump to solution
12-16-2019 07:36 AM
LisaSwarn
New Contributor III

Good Morning, 

I managed to geocode a CSV and everything matched. 

My problem? 

There are 10 projects within the attribute table but only 5 dots are showing up. This is because some of the projects happened at the same address. 

I would like to make each project its own unique point. 

How can I go about doing this? 

0 Kudos
1 Solution

Accepted Solutions
JoeBorgione
MVP Emeritus

They are unique points.  The problem is they are 'stacked' on top of one another so they 'look' like one.  The only thing I can think of off hand is to move them in an edit session so they aren't coincident. You only have a few, so it won't be so bad.  If you had dozens, or hundreds or more, then you'd probably want to come up with some kind of automated solution.

That should just about do it....

View solution in original post

3 Replies
JoeBorgione
MVP Emeritus

They are unique points.  The problem is they are 'stacked' on top of one another so they 'look' like one.  The only thing I can think of off hand is to move them in an edit session so they aren't coincident. You only have a few, so it won't be so bad.  If you had dozens, or hundreds or more, then you'd probably want to come up with some kind of automated solution.

That should just about do it....
LisaSwarn
New Contributor III

Thank you!!!

As I was editing, I realized I could just move them!! Thank you!! 

0 Kudos
LisaSwarn
New Contributor III

If it was more, you are right, there would need to be some more thought. 

0 Kudos