Select to view content in your preferred language

Extrusion

2798
1
Jump to solution
12-15-2015 03:55 PM
by Anonymous User
Not applicable

How do I extrude the feature layer in which polygons are coincident, so that they stack up on top of each other when extruded ??

Tags (2)
0 Kudos
1 Solution

Accepted Solutions
NeilAyres
MVP Alum

That would be a bit complicated because the one on top would have to have a base ht of the other plus its extrusion distance. If you have a lot of polygons that might need a programmatic solution.

If there are only a few you can probably do by hand.

View solution in original post

0 Kudos
1 Reply
NeilAyres
MVP Alum

That would be a bit complicated because the one on top would have to have a base ht of the other plus its extrusion distance. If you have a lot of polygons that might need a programmatic solution.

If there are only a few you can probably do by hand.

0 Kudos