POST
|
Dan Allen. I have no idea about EOS GNSS. As i know something for sure is that you can't say that you can achieve that accuracy worldwide. I know in Europe with R1 you can get 10 cm . But in different continents depend from coverage of the satellites, type of satellite and correction signal. So same is even for iphone. Depend from your location. 🙂 From:"Dan Allen" <geonet@esri.com> Date:Thu, 8 Oct, 2015 at 19:35 Subject:Re: - Is Collector compatible with a Trimble R1 GNSS receiver using the Trimble Viewpoint RTX correction service? GeoNet Is Collector compatible with a Trimble R1 GNSS receiver using the Trimble Viewpoint RTX correction service? reply from Dan Allen in Collector for ArcGIS - View the full discussion Apple's core location services rounds to the decimeter level for elevation from what i have seen using the EOS GNSS receiver. Does the Trimble App override the core Apple location feed and allow points to be stored to a lat long precision of 8 decimal places? Or does it get rounded up? Reply to this message by replying to this email, or go to the message on GeoNet Start a new discussion in Collector for ArcGIS by email or at GeoNet Following Is Collector compatible with a Trimble R1 GNSS receiver using the Trimble Viewpoint RTX correction service? in these streams: Inbox This email was sent by GeoNet because you are a registered user. You may unsubscribe instantly from GeoNet, or adjust email frequency in your email preferences
... View more
10-08-2015
09:47 AM
|
0
|
8
|
585
|
POST
|
Hello Mark, I found the correction. In ViewPoint RTX via satellite. Take the code directly to the vendor of the GNSS or take a trail code . There is an option at GNSS status "receiver option" where you put this code.The problem is here is not visualized if the code works or not.In this case installing TerraFlex allows your to check the code and even use the TerraFlex for correction since the correction goes on the signal so all signals will get correction Regards, Julinda
... View more
10-07-2015
01:43 PM
|
0
|
0
|
955
|
POST
|
Dear Mark, i saw you are well informed about the collector and R1.Can i asked you smth? I have done all the steps as is said on the Trimble manual . I can't select SBAS correction bcz this doesn't work in Africa. On GNSS UTILITY i have just 3 choices: SBAS, INTERNET & UNCORRECTED. How can i have a correction that covers AFRICA?
... View more
10-06-2015
04:35 AM
|
0
|
2
|
955
|
Online Status |
Offline
|
Date Last Visited |
11-11-2020
02:24 AM
|