I used the NONE value in the Population field and set a search radius such that many of the cells in the output raster included only a single point within their search radius.
I was expecting that these cells would have a value of 1.0 but they don't.
Here are input parameters for two runs of the tool:
Population field: NONE
Output cell size: 30
Neighborhood: Circle
Radius: 400
Area units: SQUARE_KILOMETERS
Cell value in cells that have a single point within the search radius: 1.989437
Population field: NONE
Output cell size: 30
Neighborhood: Circle
Radius: 500
Area units: SQUARE_KILOMETERS
Cell value in cells that have a single point within the search radius: 1.273239
Shouldn't the pixel values in both of these output rasters have been 1.0?
How exaclty are output raster cell values calculated in the Point Density tool?
Thanks
Doug Sharp