Replace geometry with paste

122
1
12-14-2012 10:57 AM
Status: Open
emmornile1
Occasional Contributor II
The advanced edting tool bar has a replace geometry button that allows digitizing of a feature to transfer attributes.
It would be good to allow a copy/paste from an existing feature rather than digitizing/tracing.
1 Comment
JasonBalmut
This can actually be done with the Spatial Adjustment toolbar.  In the drop-down part of the toolbar set up the Attribute Transfer Mapping and check the Transfer Geometry box.  Next, use the Attribute Transfer button (last one on the bar).  Make sure both layers you are using are selectable.