MS Power Automate not reading Survey123 from Enterprise Connection

Question

Hello all,

I am attempting to set up a simple automatic email on new submission to a Survey123 Survey in our Enterprise following this methodology:

https://support.esri.com/en/technical-article/000025025

I have completed steps 1-6 and am getting stuck on step 7 where testing the connection gives me the following error on 1: GetOwnedSurveyList

ERROR:

Has anyone successfully created this custom connector between Power Automate and Enterprise via new App?

Thank you for any suggestions,

abureaux · Answer

I am glad this was resolved!

Don't forget to mark your answer as the Accepted Solution.

amarcz_cc · Answer

Hey, Thank you both for the response. The error that was not allowing me to connect to the portal was two fold... 1. Wrong portal address was tacked onto the end of  Step 2. and secondly, our Certificate expired and had to be renewed.

I now have it up and running! Thanks again.

abureaux · Answer

I have not encountered this error before.

I can confirm that those steps to add a Custom Connection for S123 to PA are still valid at least. I followed them on a few occasions to get various environments set-up.

Unless this is a transient issue, this almost sounds like an IT issue on your end? Perhaps contact your IT to see if they are blocking anything.

Other than that, I can only really recommend double-checks all the steps were followed properly.

Sorry I couldn't be more help.