Survey123 Existing Feature Service Visualization Error

Question

I am creating a survey with Survey123 Connect from an existing feature service that already has data in it. When I tested adding a new datapoint only the new point shows up on the map. However, the existing data is still in the attribute table. How can I visualize all datapoints in the attribute table?

JamesTedrick · Answer

Through a conversation outside GeoNet, it was determined that the original (non-Survey123) points were misplaced due to a coordinate system mismatch.

Urban_ForestIntern · Answer

That would be great!

I did figure out that the all previously collected data got moved to 0,0 but still exists in the attribute table. all newly collected data (data collected through the Survey123 survey) shows up correctly in the right spot and at the right scale.

JamesTedrick · Answer

Hi Audrey,

Unfortunately, it's a bit hard to figure out what might be the issue based on your description- we haven't seen any behavior like the one you are describing.  Would you be willing to do a webcast to further analyze the issue?