Model Builder & Iterate Rasters - Enabling user selection

Question

Hi,

I'm using Iterate Rasters in Model Builder to run through a number of raster calculation steps on each of the source rasters in a .gdb

At the moment the model executes the process for all rasters in the .gdb.  Is there a way of just allowing the user to select a number of the rasters in the the .gdb rather than all of them by default? I imagine some sort of check box or the likes. Any suggestions would be most helpful.

Thanks

Justin

PaulLohr · Answer

Justin, did you get this to work according to your requirements?

I was after a similar concept but allowing the user to select layers from an ArcMap session.

DanPatterson_Retired · Answer

right-click on the part in the model that you want the user to interactive with and select ... make parameter... to make it a parameter...should have a P beside the oval or whatever shape it is...If there is no P beside a model step, there is no interaction with the user

JustinGleeson · Answer

Hi Dan,

Thanks for getting back with suggestions. I can see how this will allow me to select individual rasters within the model. While this is useful I can't see how this would allow the actual user at the model interface to select just the rasters they are interested in?

Thanks

Justin