Dynamic Segmentation method

SantoshV

HI,
I am developing a Road Information System application using Silverlight API (ArcGIS Server 10) and Oracle

for Road Surface Condition type I have done Dynamic Segmentation as follows
I have created a oracle view of all the attribute I required and then using ArcToolbar -->
Linear Referencing Tools -> Make Route Event Layer

I access this layer by creating a service of it, but the problem is that the application is very slow in drawing the geometry and I an also missing some roads(Geometry) here

Am I doing this the right way is there any other way of doing this?
please suggest

BeverlyPham

Hi fulcrumingenieria,
       ArcToolbar --> Linear Referencing Tools -> Make Route Event Layer creates a route event layer whch is added to the .mxd, set the symbology as needed for the event layer, then save the Map Document and publish it in the ArcGIS Server as a Map service which can be consumed directly  as a map service...

Hi Santoshf2,
I am currently using dynamic segmentation on a stretch of a river, but the attribute table of the route event layer keeps coming up blank. This is how I performed the dynamic segmentation. I created my route using the Create Route tool, and then I used the Make Route Event Layer tool to create the route event layer. There are no error messages. Do you know what I may have done wrong to create a blank attribute table for my route event layer?

I know there are two ways to create a route, which is either using the Linear Referencing tools --> Create Route tool or the Make Route on the editor toolbar. Does it matter which method I choose to create my route to perform the dynamic segmentation? Are there a benefit using one over the other or is it both the same, just two different methods?

Thank you for your help. I really appreciate it.

Sincerely,
Thi