Transfer Attributes: source feature doesn't flash when source layer is selected in transfer attributes chip

KerryAlley

I just updated to Pro 3.52, and can't get the transfer attributes tool to work: When I click the source feature, snapping tips indicate I'm clicking correctly. The transfer attributes chip appears showing the target point layer and another editable line layer. However, when I select the target point layer in the source pop-up window, the entire screen flashes instead of the feature in the point layer that I selected. The full-screen flash is what I would expect to see if I had accidentally selected an imagery/raster layer. 

There's probably something obvious I've missed, but I can't for the life of me figure out what! 😅

Scott_Harris

@KerryAlley I would not expect a full screen flash. I would have to see a video to be able to tell what could be going on. Esri Technical Support can capture this information if you think it's a bug.

If I was troubleshooting this, the first thing I would try is to check on the selectability and editability of the layers (see 1 and 2 in the image below). Source layers must be selectable .Target layers must be selectable and editable. I would then prune my list of editable layers down to only my intended target layer(s) (3 in the image below):

-Scott