One Solution CAD não reconhece polígono após converter shapefile. (Fica Preto)

Question

Estou tentando atualizar uma camada de resposta para o nosso OneSolution CAD da Centralsquare, e metade dos meus polígonos ficaram pretos por algum motivo e não estão sendo reconhecidos após o processo de conversão do geofile. Cheguei ao ponto de recriar a camada do zero para garantir que a topologia e outras partes estavam corretas. Até agora, já se passaram algumas semanas sem nenhuma pista. Alguém mais já passou por isso?

WyattGibson · Answer

Our I.T. Admin did that yesterday, so we're playing the waiting game as well.

JoshSaad1 · Answer

Yeah, I've had cases with them that have been open for years before finding a resolution.  It's bad enough their mapping platform came from the late 90's.  You might have to escalate the case to get any progress.

WyattGibson · Answer

Yeah, we already contacted Central Square. They said it was a problem on our end, and I've ran through about every option I have for modifying the data. This is one of our response driving layers, and the only layer having this issue. The CAD programming still recognizes that something should be there and pulls the run card, but you can't see the polygon. I'm not sure how far back this error goes because I found it during an audit.