Hoe bewerk je het beste percelen in Desktop Basic?

Question

<\/HEAD>Onze abonnement is op ArcGIS for Desktop Basic, dus ik heb geen toegang tot de Parcel Editor tool. Om de geometrie van percelen te wijzigen, bijvoorbeeld als een perceel wordt gesplitst en ik het moet omzetten in meerdere, verschillend gevormde percelen, moet ik dan gewoon de polygoon bewerken met de Cut Polygons Tool en de vertices van de polygonen verplaatsen om de juiste afmetingen te bereiken, of is er een betere manier? <\/P><\/BODY><\/HTML>

AdamZiegler1 · Answer

Hi Normand - The polygon to line will only break the polygon up into lines (in a new feature class). You would need to add an attribute field for length and calculate it from the geometry of the line.

http://desktop.arcgis.com/en/arcmap/latest/tools/data-management-toolbox/polygon-to-line.htm

In regards to mapped length versus deed length....that is more of an internal question for your organization. In my experience working with parcel mapping, we used the recorded deed values for frontages....which didn't always match actual geometry length (i.e. 50 foot on deed, measures 49.25 as mapped). It's probably best to show deed data, but also good to compare that with what's mapped so that you can identify data that is incorrect. In the parcel fabric, the recorded deed length is shown.

Adam Z

NormandMarchand · Answer

Adam,

Thanks for response, at the moment I am only operating on a basic license and dont have the polygon to line feature (yet fingers crossed for upgrade).  I am holding off a couple more days to see if we get the upgrade.  If we do upgrade will that tool will break down each line of the polygons with measurements?

Onto the disparity between deed and map footage.  What is the general variance with those?  Some plans that have come across my desk say a 10 FT variance.

What do you do for determination to use deed footage or map footage?

AdamZiegler1 · Answer

Hi Normand - In the Parcel Fabric there are lines with attributes for length that are labeled. If you are not in the Parcel Fabric, you could either use annotation or convert your polygons to lines, calculate lengths and then label (even take those labels and convert to annotation). The tricky part is getting the Deed frontage versus mapped frontage, typically they rarely match exactly.

Adam Z