Project Z

MAGICMuscatineAreaGeographicIn

I am trying to use the Project Z tool in ArcGIS pro but it is never prompting for the Geoid12B transformation.  Is this something that needs downloaded and imported into pro?  We have tried with meters then converted to ft.  In collector our RTK correction is broadcasting in WGS 84 and our Collector Map is in WGS 84.  We are trying to projectz to NAD83 2011 and NAVD88.

LanceCole

Mark‌,

The reason no transformation options are available is the combination of settings you have input do not have a transformation path.

ProjectZ is intended to convert the Latitude, Longitude and Altitude values collected from a GPS back into 3D points and convert the Altitude (Height Above Ellipsoid) into Elevation values.  The Latitude, Longitude and Altitude values stored from Collector are in the raw GPS data format you are utilizing.  For example, I am using a State VRS system that utilizes NAD 1983 (2011) for both horizontal and vertical. 

These are set in ProjectZ as follows for the Input Coordinate System:

Click on the Globe next to the input box

Click on the Current XY box then select:

    Geographic coordinate system > North America > USA and territories > NAD 1983 (2011)

Click on the Current Z box and select:

    Vertical Coordinate System > Ellipsoidal-based > North America > NAD 1983 2011

Click OK

You will need to determine your coordinate system being utilized by yout GPS and apply the same.  If you are using WGS84 I would guess you could try the following.

Click on the Globe next to the input box

Click on the Current XY box then select:

    Geographic coordinate system > World > WGS 1984

Click on the Current Z box and select:

    Vertical Coordinate System > Ellipsoidal-based > World > WGS 1984

Click OK

Set your X, Y and Z fields and output Feature Class

For you Output coordinate system it is the simular

Click on the Globe next to the input box

Click on the Current XY box then select:

    Projected coordinate system > State Plane > Your system > Your state system

Click on the Current Z box and select:

    Vertical Coordinate System >  North America > NAVD 1988  -  Do not select NAVD88 (height) (ftUS) at this point. 

Click OK

Note: You cannot transform directly to NAVD88 (height) (ftUS).

Run the ProjectZ

Once this completes, you can run a Project on the new feature class to go from NAVD 1988 to NAVD88 (height) (ftUS) using the same XY coordinate system.

This is explained in more detail in the post I noted previously. Is it possible to collect accurate Z coordinate values with Collector and Trimble R2?