Hi, everyone,
I have a big txt point data, it is 1.3G. also it is Lat and Long (D-M-S).
what's the right way to bring in arcgis and convert to UTM data?
I try to use them in civil 3d. thanks a lot for any suggestions.
Regards,
Jerrie
thanks, Dan,
I think it is the format GIS doesn't like, seems like it only recognize the first couple digits, so end up tons of points in one spot. If i toggle that checkbox, nothing got imported.
Could be something is wrong with the data or there are multiple points at one location. I would toggle on the last checkbox to exclude locations with improper notation
Hi, Dan,
Please don't retired. 😉 thanks for the tips. I can put the data in, but seems something is off. the output points are in one spot. any ideas?
I will try this out.
Was decimal degrees an option? rather than DMS?
There is....
Convert Coordinate Notation (Data Management)—ArcGIS Pro | Documentation
but I haven't used it or know if your input data format can be used
Aangemelde leden kunnen berichten plaatsen, updates volgen en meer. Nieuw hier? Registreer een gratis account.
Find useful guides, FAQs, and documents to help you navigate and make the most of Esri Community.
