Projection changes Spatial Reference but not X and Y.

IanHern

Hey Guys,

I am calling Project on IGeometry (its an IPoint) and its updating the Spatial Reference but not the X and Y.  Any ideas on what could be causing this?

Point X, Y, and SpatialReference.Name before projection:
-111.500208333333
52.7583416666666
GCS_North_American_1927

and after projection:
-111.500208333333
52.7583416666666
NAD_1927_UTM_Zone_5N

This is what I expect to see after the projection:
3040679.65085327
6998991.0570187
NAD_1927_UTM_Zone_5N

Cheers,
Ian

IanHern

I tried using zone 12N and the X Y didn't convert, in fact I am getting some super weird behavior.

So I have this point from a Feature Layer and I want to project it to a projected coordinate system (from a geographic one with the same datum).

When I project the point the Spatial Reference updates to be correct but the X and Y values aren't changed.

HOWEVER if I create a new Point and set the X Y and Spatial Reference to be the same as my first point, then when I project this new point the X, Y, and Spatial Reference all update.  I have spent lots of time comparing the original point and my created point and can not see any differences between them.

And ideas?

Cheers,
Pooh