3Dメッシュの生成に失敗しました

Question

Drone2Map 2024.1および2024.1.1に移行して以来、3Dメッシュを作成できていません。他のすべての製品、ポイントクラウドを含めて、正常に処理されています。 <\/P> 複数のドローンと複数のコンピューターでデータを実行しました。各ケースでログはすべての画像が処理されたことを示していますが、次のランタイムエラーが発生します。<\/P> "ランタイムエラーが発生しました：WGS_1984+WGS_1984(GXYZ 4978 PROJ 0 GEOG 4326 VERT 115700 )からGCS_WGS_1984+EGM96_Geoid(GXYZ 0 PROJ 0 GEOG 4326 VERT 5773 )への変換を探しているときにエラーが発生しました：垂直変換が見つかりませんでした"<\/EM><\/P>3Dメッシュの生成に失敗しました"<\/EM><\/P>GCPを使用し、プロジェクト座標系を画像座標系に合わせて調整し、変換が不要になるようにしましたが、それでもエラーが発生し、メッシュは生成されませんでした。 <\/P>何か提案はありますか？ <\/P> <\/DIV> <\/P> <\/P>

MarkBarker1 · Answer

Hi @StevenJacobus,

I had a flight from New York state that I tried processing in those coordinate systems as a general test. A transformation is automatically applied if you have the ArcGIS Coordinate system data installed. The processing completed with no errors for the 3D mesh generation. I wasn’t using any GCPs in my test, have you tested without the GCPs and received the same behavior?

I'd like to see your data to help troubleshoot this faster. If you are open to sharing the images and GCPs, please let me know. You can email me (mbarker@esri.com) and I will get a shared folder going.

Otherwise, please send the processing report from the project and a new d2m.log with the logging level set to debug.

Thank you,
Mark

StevenJacobus · Answer

For the image coordinate system I was using WGS 1984 for the xy and EGM96 Geoid for the z. I also tried WGS 1984 for the z since that was the default in older versions of D2M. For the Project Coordinate system I usually try for the NJ State Plane NAD 1983 StatePlane New Jersey FIPS 2900 feet and NAVD88 (ftUS), but I have tried other systems to try and get a result. I have gotten Transformations applied and when I match the coordinate systems I have gotten the message that no transformation is required but if I ask for a 3d textured Mesh I get the same runtime error in the processing log referring to the transformation I still can't find.

I attached the latest D2M log

D2M.log

MarkBarker1 · Answer

Hi @StevenJacobus ,

I had a look at the coordinate systems that you appear to be using for your projects and there are valid transformations, even without having the ArcGIS Coordinate System data installed. When you look at the processing options coordinate system section do you see a transformation being applied?

Also are you able to share the processing log and report from one of the projects? If so, include the d2m.log (C:\Users\<your username>\AppData\Local\Drone2Map\log\D2M.log)

Thank you,
Mark