ファイバーケーブルのトレースと頂点のz座標

Question

皆さん、こんにちは。<\/P> 私たちは空港のコンテキスト（屋外および屋内ネットワーク）でUN Telcoを実装しており、Chicago Datasetでいくつかの機能をテストしています。既存の3D構造を通過する新しいケーブルを描画すると、中間の頂点のz座標が0になっていることに気付きました。また、頂点がz座標が割り当てられているハンドホールの近くにある場合でも同様です。<\/P> これは2Dビューです<\/P> <\/span><\/P>そしてこれは同じケーブルの3Dビュー（断面図）で... 頂点はz = 0です<\/P><\/span><\/P>構造物のz座標を使用する方法はありますか？おそらくAttribute Rule「Line - Connection Point At Vertex」を変更することでしょうか？<\/P> <\/span><\/P>これは特に屋内ネットワークにとって重要です。<\/P>よろしくお願いします！ Damiano<\/P> <\/P>

JohnAlsup · Answer

It is difficult to know just looking at the picture, but if we assume there is only one cable, then the attribute rule we provided will not change the Z value of the cable.  The attribute rule is not designed to set the Z's of cables based on a Structure Junction's Z value. It may be easier for us to communicate directly.  My contact email address is jalsup@esri.com

DamianoMontrasio · Answer

hi @JohnAlsup first of all thanks for your interesting.

Sorry but I don't understand very well your response.

You write: "the Attribute Rule you pointed out is designed to set the Z of the cable", but my problem it's exactly that the Z of the cable is not set, also if it's created a connection Point.

Also: cable is near structure for containment associations, but is not coincident with structure.

Can you help me understand it better?

Thanks!

JohnAlsup · Answer

Since two cables cannot exist in the same x,y,z, the Attribute Rule you pointed out is designed to set the Z of the cable to ensure there is no topological conflict.  However, in our case this may not be the behavior you desire.  If so, you can remove/dispable/delete the attribute rule.  However, you will need to ensure the cables are not all occupying the same x,y,z.