Configure actions on data expression

Question

Hello,

In ArcGIS Dashboard, I managed to create an indicator with an advanced expression but I can figure out how to configure "action" on it.

By action I mean the fact that when a selector is set to a category, my indicator would only use the data of this category. Thanks a lot in advance 🙂

rezadarbari · Answer

I am dealing with a similar issue. Did you figure out how to do this?

FrankForster75 · Answer

Hi @explocarto, thanks for your answer.

Indeed, moreover the "loop" is the entire "data expression".

In order to obtain the same result with an expression in the "advanced formating" section, I would need to suceed in one of the following :

Bypass the unavailability of the "Filter" command in the expression editor

Manage to create a second reference (because it allow to filter) and use them in my expression

Thanks!

Frank

explocarto · Answer

Hello,

You get results on your entire layer because your calculations are done outside your loop.

These pre-calculations must be integrated into the loop.

I hope this helps you a bit