Erreur : Le lot ne peut pas être joint car les lignes radiales dépassent la référence spatiale

Question

<\/HEAD>J'essaie de joindre un lot dans 10.7.1 et je ne fais rien de différent de d'habitude. Je viens juste de joindre plusieurs lots à côté de celui en question. Mais quand j'essaie de joindre ce lot, j'obtiens l'erreur « le lot ne peut pas être joint car il dépasse la référence spatiale ». Il me semble que le problème vient des lignes radiales mises en surbrillance provenant de la courbe d'environ 180 degrés qui termine l'impasse. Les lignes radiales pointent vers le NE, alors qu'elles devraient pointer vers l'O, et je devrais pouvoir joindre le point radial à celui qui se trouve actuellement au milieu de l'impasse. La courbe en question a un delta de 179*40'56" et un rayon de 59*. Que se passe-t-il ici ? <\/P><\/BODY><\/HTML>

AnneBransford1 · Answer

Good thought. I've had that help with curve issues in the past, too. Just tried going through and deleting historical parcels but no luck. I still get the same error when I try to join this new parcel.

bakerd@stancounty.com · Answer

I've never had your particular error but it's worth a shot. When I have weird things happening with curves I often have to go into my historicals and delete weird historical parcels unintentionally created or historical parcels that have curve errors.  Most importantly you need to make sure you can see ALL historicals.  Not all historicals show up normally.  Go to your historicals Definition Query and change it to just

SystemEndDate IS NOT NULL

Once you do that make sure there are no historicals underneath where you are working.  I have found weird historicals and sometimes historicals with serious errors will screw up my curves.  Once I delete them my curves again function properly.

anna_garrett · Answer

oh man, maybe there's a historical or adjacent parcel causing an error? idk i've had bizarre errors happen when i have a historical/adjacent parcel with mistakes in them from legacy parcels.

maybe also restart arcmap? i was using 10.7.1 for a while but rolled back because of some of the bugs. thinking about just skipping from 10.6 to 10.8.