Impossible de configurer l'emplacement cible

RajatChopra

<\/HEAD>Bonjour,<\/SPAN>

Mon problème avec arc hydro est son étape initiale dans laquelle nous devons configurer l'emplacement Raster et Vector, chaque fois que j'essaie de faire cela et ensuite si je réalise une fonction sur DEM comme Fill SINK, cela me donne une erreur COM : - 10006 quelque chose comme ça. <\/SPAN>
Quelqu'un pourrait-il m'aider à configurer l'emplacement cible, afin que je puisse continuer le traitement<\/SPAN><\/BODY><\/HTML>

MarkBoucher

When I start a project, I open a new mxd, load in a base layer with the coordinate system I want and save it. Then I load the dem and agreestream layers as well as inner and outer wall layers I will use.

At this point, when I perform the Arc Hydro tasks, the target locations are automatically set. If I move the mxd and layers to another folder then I need to reset the target locations. (I now do my work on my C: drive, off the network, because I don't get as many errors.) The dem, agree streams and wall layers are the basis of the Arc Hydro work. (There could be others that I don't typically use like lakes/water bodies.) If these are the same, the results should be the same.

So there have been a few times where I've had problems with the target locations and simply started a new mxd added these basic layers and let Arc Hydro set the new target locations.

I found an old thread where the solution included renaming the normal.mxd and letting Arc Map create a new normal.mxd. http://forums.arcgis.com/threads/16059-Setting-Target-Locations-ArcCatalog.

I just posted some guidlines on target locations to see if others agree on my understanding. You can find there at this link.
http://forums.arcgis.com/threads/84833-Setting-Target-Locations