dynamic layer transparency

Question

I have an issue with a dynamic polygon layer not being transparent (set to 50% in arcmap) in my flex application.  I have the image output of the dynamicservicelayer as png24.  Attached is an image of what it looks like in my application.  When in arcmap, the buffers are transparent.  Any ideas or comments would be appreciated.

thanks for your time.

transparency.png

JasonLevine · Answer

You should get the behavior you're looking for if you publish an optimized msd and request png32 images. If you do this, then the exported image should maintain transparency for each pixel's alpha channel.

Dasa,
   Thanks for this tip!  I usually set my imageFormat to png24 and I always wondered why the layer transparencies I set in my mxd never got represented in the service.

-Jason

DasaPaddock · Answer

Bryan,

You should get the behavior you're looking for if you publish an optimized msd and request png32 images. If you do this, then the exported image should maintain transparency for each pixel's alpha channel.

DrewDowling · Answer

My limited understanding of this is that when the server creates an image for a dynamic map service the alphas for a layer are only relative to other layers in the same image at creation time. The image itself, once created, has only an overall alpha, this is controlled by Flex.

I don't think there is any way to control the alphas of individual layers using flex unless you create a service for each layer.

I could be wrong on all of this.